MZ TS 125/150
From Wikipedia, the free encyclopedia
 MZ TS 150 de Luxe (built in 1979) | |
| Manufacturer | VEB Motorradwerk Zschopau |
|---|---|
| Production | 1973–1985 |
| Predecessor | MZ ETS 125/150 |
| Successor | MZ ETZ 125/150 |
| Engine | → see table |
| Related | MZ TS 250 |
The motorcycles MZ TS 125 and MZ TS 150 were built at the VEB Motorradwerk Zschopau between 1973 and 1985. The further development based on the ETS 125 and ETS 150 and was presented to the public for the first time at the Leipzig Autumn Fair in 1972.[1] The series production began in June 1973.
The abbreviation TS in the model name stood for Teleskopgabel, Schwinge (english: Telescopic fork, Swingarm).[2]
The manufacturer's aim was not a new development, but essentially a visual revision of the predecessor ETS 125/150 and an improvement in suspension comfort. The model received a longer suspension travel on the telescopic fork, a new fuel tank with a capacity of 12 l, the shape of which was based on that of the TS 250, and new side panels. The MM 125/150/2 two-stroke engines that had proven themselves in the ES and ETS models were used, and only the connecting rod bearing and crankshaft details were changed, which made the latter more stable. The previous single sleeve chain for the primary drive was replaced by a duplex chain. The parts of the electrical system were the same as on the TS 250: DC alternator with 60 W output, headlights with 170 mm diameter, asymmetrical dipped beam with 45/40 W dual-filament bulb and 21 W output on the back.[1][3][4][5]
As with all MZ models, starting with the RT 125/1, the secondary chain is fully encapsulated with the chain guard made of rubber hoses and the chain case made of Duroplast on the rear wheel hub.
Facelift
Over the course of the production period there were continuous external and technical changes.
From spring 1977, the TS was equipped with the improved MM 125/150/3 engine. Now the crankshaft disks and crankshaft stumps were made from one piece, and the stumps were larger in diameter. The crankshaft bearings were improved with radial ball bearings. The piston pin received a needle bearing. The fuel-oil mixture ratio could be reduced for these engines from 33 : 1 to 50 : 1. This made the small TS the last GDR vehicle on which the reduction in the oil proportion to 50 : 1 was implemented.[6]
Number of units
In the first years of production, the series was produced in parallel with the predecessor series ES 125/1 and ES 150/1 (1969–1977). A total of 163,409 (TS 125) and 326,052 machines (TS 150) were manufactured. 88% of the production of the TS 125 model was exported.
Specifications
| TS 125 | TS 150 | |
|---|---|---|
| Production | 1973–1985 | |
| Engine | airstream-cooled single cylinder Two-stroke engine, Kick start | |
| Design | piston-controlled inlet port | |
| Bore × Stroke | 52 mm × 58 mm (2.0 in × 2.3 in) | 56 mm × 58 mm (2.2 in × 2.3 in) |
| Displacement | 123 cc (7.5 cu in) | 143 cc (8.7 cu in) |
| Compression ratio | 10 : 1 | |
| Power rating | 10 PS (7.4 kW) at 6300/min | 11.5 PS (8.5 kW) at 6000/min |
| max. Torque | 12.3 N⋅m (9.1 lbf⋅ft) at 5500/min | 14.7 N⋅m (10.8 lbf⋅ft) at 5000/min |
| Introduction of fuel | BVF-carburetor, intake diameter 22 mm (0.87 in) | BVF-carburetor, intake diameter 24 mm (0.94 in) |
| Lubrication | total-loss lubrication system, fuel-to-oil ratio 33 : 1; from 1977: 50 : 1[7] | |
| Ignition system | battery ignition, contact-controlled | |
| Alternator | DC dynamo generator, 6 V – 60–90 W | |
| Battery | 6 V – 12 Ah | |
| On-board voltage | 6 V | |
| Clutch | multi-disk clutch in oil bath, mechanically operated | |
| Transmission | 4-speed helical gearbox, claw-switched; chain drive (fully encapsulated) | |
| Frame | pressed steel frame | |
| Dimension (L × W × H) | 2,045 mm × 735 mm × 1,175 mm (80.5 in × 28.9 in × 46.3 in) with high handlebar; 2,045 mm × 620 mm × 1,115 mm (80.5 in × 24.4 in × 43.9 in) with flat handlebar | |
| Wheelbase | 1,305 mm (51.4 in) | |
| Front suspension | telescopic fork, hydraulically damped, suspension 185 mm (7.3 in) | |
| Rear suspension | swingarm, 2 struts, suspension 105 mm (4.1 in), adjustable spring base | |
| Front rim size | wire-spoke wheel, 1.6 x 18″ | |
| Rear rim size | wire-spoke wheel, 1.85 x 18″ | |
| Front tire | 2.75–18 M/C 48P TT | |
| Rear tire | 3.00–18 M/C 52S TT | |
| Front brake | simplex drum brake, diameter 160 mm (6.3 in), bowden cable operated | |
| Rear brake | simplex drum brake, diameter 150 mm (5.9 in), bowden cable operated | |
| Curb weight | 113 kg (249 lb) | 115 kg (254 lb) |
| Maximum load | 270 kg (600 lb) | |
| Fuel capacity | 12,5 l (Reserve: 1.5 l) | |
| Top speed | 100 km/h (62 mph) | 105 km/h (65 mph) |
