Design load
From Wikipedia, the free encyclopedia
In general, the term design load can refer to two distinct concepts:
- the maximum amount a system is designed to handle, or
- the maximum amount the system is capable of producing.
These interpretations represent fundamentally different aspects of system performance. The design load is either the same as or a multiple of the rated load, which represents the system's declared performance capacity, see structural design load section below.
Structures and pressure vessels have design loads of the first type. Electric motors, compressors and heaters have design loads of the second type. Cranes have design loads of both the first and second type because they have to lift a defined load and do that at a specified speed.
A crane's rated load is its Safe Working Load (SWL) and the design load (DL) is, (p 90)[1]The dynamic lift factor for offshore cranes in the range 10 kN < SWL ≤ 2500 kN is not less than .(p 84)[1] Thus for a crane with a SWL of 2000 kN (~200 tonne) its design load is not less than,The minimum breaking load (MBL) for the combined capacity of reeves of a steel wire hoisting rope required on this size of crane is, (p 68)[1]Thus the MBL is 2.3 times of the DL and ~3 times that of the SWL for this example. Similar ratios are obtained for other parts of the crane's structure. This factor of safety has been shown to be required when a failure could be catastrophic, such as a crane dropping its load or collapsing entirely. The dynamic lift factor increases as the SWL of a crane decreases and its exact value is dependent on the hoisting speed of the crane and other factors. These calculations are more complex and beyond the scope of this article.[1]
