Pythium volutum

To combat Pythium volutum there are a few steps that can be taken. Some cultural control steps that can be taken are monitoring irrigation and also increasing drainage through aeration. Because Pythium spp. are water molds, the management of irrigation will lower the risk of infection of the turf. Also, aeration will allow for excess water to exit the area and reduce risk of infection.^[4] Removing excess water doesn't allow for spore movement from root to root. Finally, adjusting mow heights will reduce stress on the plant and therefore will make the plants less susceptible to damage by the pathogen. Chemical treatments are another option for management and control. Fungicides can be applied during the infection periods of Pythium volutum to reduce the occurrence of infection of creeping bentgrass. In fact, both cultural and chemical methods of management should be used in tandem for most effective results.^[5] Fungicides work by killing the fungi and the fungal spores, effectively managing the disease.

Beginning with an already infected, dead plant, Pythium volutum enters its sexual stage. In this stage, an oogonium is fertilized by an antheridium. Pythium voultum is usually fertilized by one antheridium, but has been observed being fertilized by as many as four antheridia at a time, which is different from other Pythia spp. After fertilization, an oospore is produced. Oospores are resting structures that allow the pathogen to overwinter in the soil. Once the oospore is formed, the oospore will either begin to produce zoospores or begin to germinate and directly infect new plants itself.^[6] Because of this fact, the initial inoculum can be either considered the oospore itself or the zoospores that emerge from the oospore. Dissemination of these spores is reliant on water. Zoospores specifically use water to swim to the host. Once the infectious spores reach the host's root tissue, infection occurs. This infection is a systemic infection resulting in chlorosis, wilting, and ultimately plant death. Before plant death occurs, the infected plants produce structures called sporangia. Sporangia can then be disseminated by the wind, rain, or mechanical factors to reach new hosts. Once the sporangia reach a new, uninfected host, zoospores are released. These zoospores produced by the sporangia again use water and moisture to swim to openings or wounds in the bentgrass. This is different from the initial inoculum because these spores may enter through other plant structures than the root tissue. From this point, the infected plant will eventually die and the pathogen will again overwinter in the oospore structures. Infection of grass occurs in fall and spring. This is when soil temperatures and moisture levels are optimal for spores to infect the roots of plants.^[3]